Tekonsha 90885 Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional

Instructions: Installation Details.pdf

Features

Brake controller activates trailer brakes in proportion to your vehicle's braking action
Automatically adjusts trailer's braking based on deceleration of tow vehicle
Activates immediately - no pausing like with time-delayed brake controllers
Automatic-leveling ability - internal sensor detects deceleration even if controller is not mounted flat
Position anywhere from 0 degrees (level) to 90 degrees in the vertical plane
3 Boost levels let you adjust initial braking power and aggressiveness
Continuous diagnostic check alerts you to any potential problems
Integrated safeguards protect your vehicle and trailer
Minimizes drain on car battery when not in use
Prevents trailer brakes from overheating by reducing power output to them during prolonged stops
Easy-to-read LED display
Built-in. slide-bar manual override
Quick-disconnect feature lets you easily remove and store the control when not in use
Replacement wiring harness (sold separately) and replacement bracket (6927 - sold separately) required to move the controller from one vehicle to another
Plug-in. vehicle-specific brake-control adapter (sold separately) can be used for certain applications to reduce installation time

Specs

Vertical Range: 90 Degrees
Automatic leveling: yes
Axles: 1-3 braking axles
Display: Digital LED 
Boost: yes
Warranty: Limited Lifetime

Draw-Tite® is the premier brand of custom trailer hitches. Established in 1946 and created with a passion for outstanding performance the brand has come to represent one of the best custom fit vehicle products available today. Each hitch design must pass rigorous testing to become TESTED TOUGH™. The addition of increased tongue weight capacity and an all new accessory pairing guide make the Draw-Tite brand your best choice for years of dependable service. With a proportional brake controller, you can get heavy-duty emergency braking, general braking or slow-to-an-idle braking for your trailer automatically. The intensity with which your trailer brakes are activated and the rate at which they are applied are dependent on the deceleration of your tow vehicle.

This means that, unlike time-delay controllers - which send the same amount of preset power to your trailer brakes every time - proportional controllers are able to adapt to every braking situation differently. So, if you slam on the brakes in your truck, your trailer brakes will activate with that same extreme intensity. And if you merely slow down as you approach a red light, your trailer will gradually brake in the same manner. Just set the initial power level, select a boost setting, and you're good to go. As long as the P2 controller is properly mounted and is pointed in the direction of travel, it will sense - via an internal inertia sensor - how your tow vehicle brakes. This inertia-based sensor responds to the deceleration of your tow vehicle as you brake by signaling the controller to send out enough power to your trailer brakes so that they are activated with an intensity that matches. The result is uniform braking across your towing setup. No push-pull action - just smooth, proportional braking every time.